Yealink W80DM Multi-Cell DECT Manager

Description

The Yealink W80 DECT Manager is a management device designed to work with the Yealink W80B Multi Cell DECT System. The W80B serves as the base station for the DECT system and allows the registration of handsets.

To use the W80 DECT Manager, you must have the W80B base station. The W80B base station acts as the central control unit for the DECT system, handling the registration, management, and routing of calls to the connected handsets.

Here are the steps to register handsets with the Yealink W80B Multi Cell DECT System using the W80 DECT Manager:

Connect the W80 DECT Manager to the W80B base station. Ensure they are properly connected and powered on.

Access the W80 DECT Manager’s web interface using a computer or device connected to the same network. You can typically access the web interface by entering the IP address of the W80 DECT Manager into a web browser.

Once logged in to the W80 DECT Manager’s web interface, navigate to the handset registration section. This section should provide options for registering and managing handsets.

Follow the instructions provided in the web interface to register handsets. Typically, this involves putting the handsets into registration mode and then initiating the registration process from the web interface. The specific steps may vary depending on the model of the handset.

After initiating the registration process, the W80 DECT Manager will communicate with the W80B base station to register the handsets. The handsets should then be able to connect to the DECT system and make/receive calls.

Please note that the above steps are a general guideline and may vary based on the specific model and firmware version of the Yealink W80 DECT Manager and W80B Multi Cell DECT System. It’s always recommended to refer to the product documentation or reach out to Yealink support for detailed instructions tailored to your specific setup.