Yealink W90DM Multi-Cell DECT Manager

Description

The Yealink W90 is a Multi-Cell DECT Manager designed to work with the Yealink W90B Multi-Cell DECT Base Station. The W90B serves as the base station for the DECT system, and the W90 DECT Manager is used for managing and configuring the system.

To register handsets with the Yealink W90B Multi-Cell DECT Base Station using the W90 DECT Manager, you would typically follow these steps:

Ensure that the W90 DECT Manager and W90B Multi-Cell DECT Base Station are properly connected and powered on.

Access the web interface of the W90 DECT Manager using a computer or device connected to the same network as the DECT system. You can usually access the web interface by entering the IP address of the W90 DECT Manager into a web browser.

Once logged into the web interface, navigate to the handset registration section. This section should provide options for registering and managing handsets.

Follow the instructions provided in the web interface to register handsets. Typically, this involves putting the handsets into registration mode and initiating the registration process from the web interface. The specific steps may vary depending on the model of the handset.

After initiating the registration process, the W90 DECT Manager will communicate with the W90B Multi-Cell DECT Base Station to register the handsets. The handsets should then be able to connect to the DECT system and make/receive calls.

Please note that the steps mentioned above are a general guideline, and the exact process may vary based on the specific model and firmware version of the Yealink W90 DECT Manager and W90B Multi-Cell DECT Base Station. It is always recommended to consult the product documentation or reach out to Yealink support for detailed instructions tailored to your specific setup.